Beisler 1911-4 - Manual (Page 73)

- D 73 -
Short Seam Automat 1911-4 / 1912-4 Working Instructions Beisler Automated Sewing Equipment
D.3
Programming
D.3.2 Service menu start level
NOTE - Check settings!
The settings must be checked using a sewing piece; if re-
quired, they must be corrected.
Manual actuation of the thread clamp:
After the top thread has been passed through the need-
le, the thread clamp is actuated manually to protect the
top thread from being pulled out of the needle when a ma-
chine cycle starts.
• Press
key.
Filling bobbin
Insert thread and fill bobbin:
• Press
key.
Q
Acknowledge status messages on display:
If the message SPOOL EMPTY is displayed, insert a full
bobbin and
• Press
% key.
If the message SPOOL: 004 M is displayed when a full
bobbin is inserted
• Press
key twice.
NOTE - Rest thread monitor sensitivity
If the bobbin is empty and the display does not show a
status message, the photocell sensitivity must be adjus-
ted (see Section C, Service Instructions).
Resetting the insertion process:
This function depends on the mode of machine operati-
on. It refers only to machine movements that can be per-
formed before the automatic operation.
The machine movements will be reset to start position.
• Press key (several times if required).
"