Basler Electric BE1-87T - Manual (Page 6)

iv BE1-87T Introduction 9171300990 Rev V
Manual
Revision and Date
Change
M, 04/99 
Table 3-1 changed mid range nominal volt 125 Vac to 120 Vac.

Corrected Figures 4-24, 4-31a, and A-3

Corrected page 4-38, Step 10; added note to page 4-39, Step 13, and
corrected Steps 14 and 16.

Page A-2, changed 3-Phase fault ratio current to 3-phase fault
current.

Page A-3, corrected formulas for Figure A-3.

Under Section 4, Procedure One, Verify CT Performance, changed
the procedure to the ANSI accuracy class method. This forced
changes in the following steps: 12, 13, 14, 16, 18, 20, and 21.

Under Section 4, Procedure Two, Verify CT Performance, changed
the procedure to the ANSI accuracy class method. This forced
changes in the following steps: 12, 13, 14, and 16.

Added ECO revision information to Table 8-1.

Added Setting Note 7 (ANSI Accuracy Class Method) to Appendix A.
L, 05/97 
To delete the part number from the front cover of the manual.
K, 03/97 
Deleted all references to Service Manual 9171300620.

Changed the Title of Section 2 from “Controls and Indicators” to
“Human-Machine Interface”.

Replaced the Power Supply Options paragraphs with a new Power
Supply paragraph explaining the new power supply design.

Deleted Figure 3-2 and added Table 3-1, Wide Range Power Supply
Voltage Ranges.

Changed Power Supply Status Output for Type G power supply on
the formerly page 3-6 (now page 3-4) from terminals 9 and 20 to
terminals 9 and 19.

Added information to Section 4 to help the user understand the
procedures better.

Deleted all NOTES FOR USERS OF SENSING INPUT TYPE F
RELAYS and added Section 7, Difference Data.

Changed previous Section 7, Manual Change Information, to Section
8.

Added an Appendix A to clarify the setting procedures.

Added an index to help the user find information easier.

Changed the format of the manual.
J, 01/96

Deleted “Difference Data” (formerly Section 7) and included notes for
users of Type F relays.

Moved all information regarding relay settings and checking relay
setting from Section 5, Testing and Setting, to Section 4, Installation.
Section 5 now contains information on test procedures.

Combined 50 and 60 Hz Verification Tests.

Various editorial changes.

Reformatted instruction manual as Windows Help file for electronic
documentation.