Basler Electric BE1-87T - Manual (Page 19)

9171300990 Rev V BE1-87T General Information 1-7
Outputs Output contacts are rated as follows.
Resistive
120/240 Vac Make 30 A for 0.2 seconds, carry 7 A continuously and break
7 A.
250 Vdc Make and carry 30 A for 0.2 seconds, carry 7 A continuously
and break 0.3 A.
500 Vdc Make and carry 15 A for 0.2 seconds, carry 7 A continuously
and break 0.1 A.
Inductive
120/240 Vac, 125/250 Vdc Make and carry 30 A for 0.2 seconds, carry 7 A continuously
and break 0.3 A, (L/R = 0.04).
Target Indicators Target indicators may be either internally-operated or current-
operated (operated by a minimum of 0.2 A through the output
trip circuit). When the target is current-operated, the
associated output circuit must be limited to 30 A for 0.2
seconds, 7 A for 2 minutes and 3 A continuously.
Single-Phase Units Either an internally-operated or a current-operated target is
supplied (as selected by the Style Number) for each trip
output (i.e., the restrained and the unrestrained functions).
Three-Phase Units Either internally operated or current operated targets (as
selected) indicate the function (restrained or unrestrained)
that caused the trip, and the tripped phase (A, B, C).
Harmonic Attenuation Refer to Table 1-2.
Table 1-2. Harmonic Attenuation
Parameter
(50 Or 60 Hz Models)
Minimum Attenuation at Indicated Fundamental
50/60 Hz 100/120 Hz 150/180 Hz 250/300 Hz 500 Hz
Through Current 0 0 0 0 12 dB
Operating Current 0 0 0 0 12 dB
2nd Harmonic Restraint 12 dB 0 12 dB 12 dB 12 dB
5th Harmonic Restraint 12 dB 12 dB 12 dB 0 12 dB