1 static mode, 2 dynamic mode – D-Link DRO-210i User Manual
Page 15
Interfaces
Dlink DRO-210i User Guide
15
2.4.1 Static Mode
In this mode, the ISP allocates and provides a static Global IP Address for WAN
connectivity. The ISP will also provide information regarding the Default Gateway IP
Address to be used for this connection.
If you have purchased multiple static Global IP Addresses from the ISP, then configure
the first IP Address as the WAN Interface IP Address. And use the rest of your static IP
Addresses for Many-To-Many or One-To-One NAT Configuration.
Select Interface →
→
→
→
WAN1 and choose IP Setting Mode as Static. Configure IP
Settings for WAN1 Interface as explained below.
IP Settings for WAN1 Interface
IP Address
Enter the IP address assigned for the WAN interface
Subnet Mask
Enter the subnet mask for the IP address
Default Gateway
Enter the default gateway address (in the same subnet).
MTU
Enter the MTU value for the WAN. Default value is 1500.
Click on Detect Link Status to configure the
Feature.
Note:
The default gateway field specified here will be used by Load balancing feature
to route packets through this interface.
2.4.2 Dynamic Mode
In this mode, ISP provides the Global IP address automatically using DHCP Protocol. A
DHCP Client is built into router to support this mode of connectivity.
Select Interface →
→
→
→
WAN1 and choose IP Setting Mode as Dynamic. Configure DHCP
Settings for WAN1 Interface as explained below.
DHCP Settings for WAN1 Interface
Host Name
(optional)
Enter the hostname assigned for the WAN interface
MAC Address
Displays the MAC address of the router’s WAN Port.
MTU
Enter the MTU value for the WAN. Default value is 1500.
Web UI
Web UI