Axel AX4000 User's Manual User Manual
Page 89
Appendix
AXEL Office Server
83
For example:
BEGIN_AX4010_SETUP V1.1
# this is a comment
tcp_host1_name=vangogh
...
END_AX4010_SETUP
Note: lines beginning with '#' are treated as comments and ignored.
Set-up parameters are divided between the following parameter groups:
Ethernet:
Ethernet interface parameters,
TCP/IP: network
environment,
Ch1 Port:
port service and communication parameters,
Ch2 Port:
port service and communication parameters,
Ch3 Port:
port service and communication parameters,
Ch4 Port:
port service and communication parameters.
And only for the AX4020:
Ch5 Port:
port service and communication parameters.
Ch6 Port:
port service and communication parameters.
Ch7 Port:
port service and communication parameters.
Ch8 Port:
port service and communication parameters.
Several formats are available for set-up parameter values:
List:
the possible values are listed (the character '|' is
used as a separator).
Examples:
(yes | no).
(none | xon-xoff | xpc | dtr)
Number:
maximum and minimum values are given.
Character string:
maximum length is given.
Note: an ASCII character can be represented by its
hexadecimal ASCII code, preceded with a
backslash character (e.g.: \1B represents Escape
and \\ represents a backslash).
IP address format:
the IP address format is xxx.xxx.xxx.xxx.
In the following parameter lists, the possible values are bracketed after each
set-up parameter.