Axel AX4000 User's Manual User Manual
Page 63
Downloading
Firmware
AXEL Office Server
57
b) The Office Server accesses the tftp host via a router
net:hn:df=/etc/btdump:ht=ethernet:sa=192.1.1.243:to=auto:
net1:tc=net:sm=255.255.255.000:gw=192.168.1.252:
axel1:tc=net1:ht=ethernet:vm=rfc1048:ha=00A034100001:ip=192.168.1.242:bf=
/usr/axel/firm9801:
IMPORTANT: if a problem occurred during a previous download operation
(whatever method was used), the firmware of the target Office Server may have
been erased. To restore valid firmware, the bootp+tftp protocol will
automatically be run when this target Office Server is turned on.
5.3.1 - By a rsh Command
The rsh command syntax is as follows:
# rsh axname ax_download file tftpIP routeIP
- axname: Office Server hostname listed in /etc/hosts,
- ax_download: command option for firmware downloading,
For example:
# rsh ax4011 ax_download
The following error message can be displayed (on the operator’s console):
- ERR 105: invalid rcmd command: incorrect command option
(check the syntax).
Note: other error messages can also be displayed (connection time-out, for
example). For explanations refer to your system manuals.
5.3.2 - From the Interactive Set-Up
Use a serial terminal or a telnet connection to access the interactive set-up
(cf. chapter 2.1). Select [Download Firmware]
→[Download by boot + tftp].
After confirmation, the download operation is run.