Axel AX4000 User's Manual - Manual (Page 36)

Setting-Up the Office Server in Interactive Mode
30
AXEL Office Server
Answer 'y' to set-up a backup host. The following parameters are asked:
- Backup Host Name / IP Address: name or IP address
- TCP Port: numeric value associated with the service.
- Timeout to Enable Backup: maximum delay allowed (in seconds) to
open a connection to the primary host. If the connection fails, the Office
Server opens a connection the backup host.
- Backup Host Priority: two answers:
- 'n': backup host has not priority. That means for each connection
the Office Server try first to open a connection to the primary host
(even if a previous primary host connection failed).
- 'y': backup host has priority. That means if a connection to the
primary host fails, the backup host will be used for the further
connection (until the Office Server is rebooted).
2.7 - SECURITY ISSUES
2.7.1 - Password
Select [Advanced Set-Up] →[Password]:
- to set a password
- to remove a password previously entered (left the password blank).
If the set-up is password-protected, the password is required when the set-up is
entered (three tries are allowed).
IMPORTANT : if the password is forgotten, the super password 'yaka' can be
used.
2.7.2 - Changing the Set-Up TCP Port
The Office Server Set-Up can be run within a telnet session with the TCP port
4906.
This TCP port can be changed. Select [Advanced Set-Up] →[Tunings] and set
the 'Setup tcp port' parameter.