Axel AX4000 User's Manual User Manual
Page 25
Setting-Up the Office Server in Interactive Mode
AXEL Office Server
19
Parameters needed for all three types of lines (direct, dedicated and telecom):
- Data Transfer Rate: speed in bps
Values: 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600 or
115200.
- Data Format: size of data, number of stop bits and parity. A slash (/) is
used to separate the 3 values.
Size of data: 7 or 8 bits
Stop bits: 1 or 2 bits
Parity: none, even or odd
Example: 8/1/none.
- TX FIFO Size: size of the internal buffer allocated for data flow control
(from 1 to 16 bytes).
- Input Flow Cntl: handshake used by the Office Server to control the
peripheral’s data flow.
Values: none, xon, xpc, rts or dtr.
- Flow Cntl Chars Passthru : if yes (y), when a software handshake is
used by the peripheral, the handshake control characters (xon/xoff and
xpc) are both locally processed and sent over the network. if no (n), the
handshake control characters are only locally processed.
- Output Flow Cntl: handshake used by the peripheral to control the
Office Server’s data flow.
Values: none, xon, xpc, cts or dsr.
- Peripheral Presence Signal: signal used by the Office Server to detect
the peripheral’s presence. The possible values depend on the LINE
TYPE value:
- Direct line: none, cts or dsr.
- Modem or dedicated line: cts, dsr or soft. The 'soft' value allows
detection of the modem’s presence. Type in ‘AT
modem should answer ‘OK’.
- Net Close on Pres. Lost (requested only if Line Type is direct and
Peripheral Presence is enabled): if yes (y), the network service is closed
when the peripheral presence signal is dropped. If no (n), the network
session is not closed when the peripheral presence signal is dropped.