Avery Dennison 7410 MonarchNet2 Smart Relay - Manual (Page 2)

2
I n i t i a l S e t u p P r o c e d u r e s
1. Connect the printers. See “Connecting the Printers,” for more
information.
2. Turn on the partner printer.
3. Configure the Partner Printer. See “Configuring the Partner Printer,” for
more information.
4. Turn off the partner printer.
5. Turn on the primary printer.
6. Configure the Primary Printer. See “Using the Smart Relay Telnet
Commands,” for more information.
7. Turn off both printers.
8. Turn on the primary printer. Wait until you see "Smart Relay Ready,"
then turn on the partner printer.
9. Send your data.
Note: Follow these steps as listed otherwise, errors may occur.
A b o u t t h e P r i m a r y P r i n t e r
The primary printer
♦ must be a 9855 printer using MonarchNet2 software
♦ can have only one partner
♦ connects to the partner printer using a serial cable. You cannot use the
optional external keyboard with the primary printer.
Note: There is no bi-directional communication between the primary and
partner printers.
For maximum efficiency, the primary printer should print the majority of the
supplies. If you print more RFID supplies than non-RFID supplies, make the
RFID printer the primary printer. This reduces the amount of data transferred
to the partner printer and requires less processing by the primary printer.
All formats, graphics, fonts, or check digits used with the Smart Relay
system must be sent to the primary printer. See “Connecting the Printers”
and “Configuring the Partner Printer” for more information.