Avery Dennison 7410 MonarchNet2 Smart Relay - Manual

Monarch , MonarchNet2, Smart Relay, 7410, 9850, 9855, and 9860 are trademarks of Paxar Americas, Inc.
Paxar is a trademark of Paxar Corporation.
TC7410MN2AD Rev. AB 5/07 2005 Paxar Americas, Inc. All rights reserved.
M O N A R C H N E T 2  A D D E N D U M
Using Version 3.1 or greater firmware, the Monarch  9855 printer supports
the Monarch  Smart Relay System powered by MonarchNet2 software.
To use MonarchNet2 software, your printer must contain the Monarch 
7410  Ethernet Print Server.
This addendum is for the System Administrator, who configures and
manages the printers over a network.
S m a r t R e l a y O v e r v i e w
The Smart Relay System consists of two printers (primary and partner)
connected with a serial cable. Based on the type of data sent, the batch
prints to the appropriate printer. The primary printer must be a 9855 printer
with Version 3.1 or greater firmware using MonarchNet2 software. The
partner printer can be a Monarch
 9855 or 9860 printer.
The primary printer forwards the batches, according to the Smart Relay
configuration. Use this addendum to configure the Smart Relay commands
using Telnet. This addendum assumes a basic understanding of the Telnet
application. The default port is TCP/IP Port 9100.
Additionally, you can number all the labels in a batch with a collation number
that prints on every label. The primary printer controls the collation number,
according to the Smart Relay configuration.
Note: If you need to turn off either printer, turn off the partner printer first,
then, turn off the primary printer. When powering on the Smart
Relay Printing System always turn on the primary printer first, then
wait until you see "Smart Relay Ready," before turning on the
partner printer.