Avery Dennison FreshMarx 9415 System Administrator Guide - Manual (Page 36)

U p d a t i n g t h e A p p l i c a t i o n
Single Printer & Dual Printer Application Software Description
There are two versions the Application Software; Single Printer and Dual Printer. The
Single Printer version (2.7 or higher) can be installed on a dual printer. When this is
done, the user presses the appropriate printer button (P1 or P2) to tell the printer
which to use. The default is Printer 1. If Printer 2 is chosen, it stays in effect until the
user changes the selection or the printer is turned off and back on.
Note: The Dual Printer Application Software cannot be installed on a single printer.
Updating using a network cable:
1. Download the latest application from our Web site on your computer.
Note: Save the file to your computer’s hard drive, not a network drive.
2. Connect the printer to your computer using an Ethernet cable.
3. Turn on the printer.
4. Start the Edit Utility.
5. Click Update, Application Software.
6. Open the freshmarxVxx.bff (“xx” indicates the version number) file you downloaded
from the Web site.
The printer enters download mode. This may take several minutes. When the update is
complete, you see “Update Complete” in the status bar of the Edit Utility. The printer
restarts automatically and loads the latest application.
Updating using a USB thumb drive:
1. Download the latest application from our Web site.
2. Save it on your thumb drive.
3. Plug the thumb drive into the USB port on the side of the printer. The printer
detects the thumb drive automatically.
U S B P or t
4. Press .
4-6 System Administrator’s Guide