Avalon Firestyles AGP Pellet Insert - Manual (Page 8)

ZC Kit – AGP Pellet Insert
(94400157)
Page 8 of 10 17601823 - 3/7/14 © Travis Industries, Inc.
Insert Preparation and Placement
 Place the extending hopper into its highest position (see the manual for details). This increases the pellet
capacity of the heater.
 Install the surround panel onto the insert and slide it into place. Do not slide the insert all the way into
the enclosure - the surround panel must maintain a 3/8” gap to the enclosure opening (the stand-
offs on the surround panel extend 3/8”).
 The leveling bolts may be used to level the insert.
 We recommend the use of the Insert Wiring Kit when installing this kit (SKU 97200315). This kit allows
for the power cord to be hard-wired behind the walls, eliminating the need for a visible power cord.
Horizontal Vent Example
Wall Thimble (note 3" clearance
between vent and combustibles)
12"
Minimum
House Shield
(prevents soot discoloration)
HIGHLY RECOMMENDED
Floor Protection
Make sure vent maintains 3"
clearance to any combustible.
Do not slide the insert all the way into the
enclosure - the surround panel must maintain
a 3/8" gap to the enclosure opening (the
stand-offs on the surround panel extend 3/8").
Attach elbow directly to insert (do not use an
appliance adapter). Seal connection with
silicone and secure with screws.