Avalon Firestyles AGP Pellet Insert - Manual (Page 7)

ZC Kit – AGP Pellet Insert
(94400157)
Page 7 of 10 17601823 - 3/7/14 © Travis Industries, Inc.
ZC Can Placement
 Place the bottom panel inside the enclosure. Place the zc can on top of the bottom panel (the edges of the zc
can line up with the edges of the bottom panel). Make sure the front edge of the zc can and bottom panel are
flush with the enclosure opening (see illustration below). Secure the zc can to the bottom panel (and sub
floor) with the 7 included 1-1/4” screws.
When installed, the enclosure opening,
bottom panel, and zc can must be flush.
2-1/2" Min.
(both sides)
Secure the zc can to the
bottom panel (and sub
floor) with the 7 included
1-1/4" screws.
Bottom
Panel
A knock-out is provided on each side for
routing the optional insert wiring kit.