Avalon Firestyles Flush Wood Plus Cypress Face - Manual (Page 4)

Flush Wood Plus Cypress Face Installation
(95600565)
Page 4 of 7 17601651 - Printed 9/18/12 © Travis Industries, Inc.
7. Attach one of the extension rods from this kit to the back of the existing air control rod assembly.
NOTE: If the power cord is routed onto the hearth, make sure to remove the tab on the face, as shown below
(either side may be used).
Figure 12: Cut‐away in face Figure 13: Bending the tab on the face
Figure 14: Removing the cut‐away covering
8. Place the bottom section of the face near the insert. Connect the wires at the bottom left and right sides of the
face.
Figure 15: Connecting the bottom left wires Figure 16: Connecting the bottom right wires