Avalon Firestyles High-Temperature Wood Insert Wiring Kit - Manual (Page 2)

High-Temperature Wood Insert Wiring Kit
97200337
Page 2 of 6 1/31/14 - 17601776 © Travis Industries, Inc.
3 Route the conduit on the wiring harness through the fireplace to a junction box outside of the fireplace.
Junction Box
(mounted outside the fireplace)
Conduit may be run through a suitable hole
or ash trap (you may wish to seal this area
to prevent cold air infiltration).
Do not run the conduit
under the insert.
Attach the "This fireplace has been altered..."
plate to the fireplace (included with the insert).
You may wish to place it in a location where it
will be covered by the surround panels.
4 The fireplace insert should be placed on the fireplace hearth in position to access the right side of the insert.
5 Use a screwdriver to remove the button plug on the side of the insert. Discard the button plug.
6 Route the molex plug on the wiring harness through the hole on the right side of the insert. Then reach in
from the front of the insert and pull the molex plug forward.