Avalon Firestyles Outside Air Kit - Manual (Page 4)

Outside Air Kit
99200139
Page 4 of 4 17601452 - 9/7/12 © Travis Industries, Inc.
Installation with Legs
3" Dia. Flex Duct
(4' max. length)
Hood with Rodent Screen
Silicone
Seal the area around
the tube to prevent
air from entering
through the wall.
Silicone
All Stoves Except Leyden,
Arbor, Cape Cod:
Secure flex duct to air duct
assembly using the included
hose clamp. Attach air duct
assembly to stove with two
included #8 screws.
Slide the cover plate
over the flex duct then
attach the flex duct to
the hood with the
included hose clamp.
Secure the cover plate
to the wall with the
included screws (and
drywall anchors if
needed).
HINT: The flex must be
fully stretched and the
ends cut square and
flatted for it to fit
properly. The tube on
the hood and air duct
may be crimped if
necessary.
Cover Plate
Stove
b
8"
Select a location between
framing members for the
wall penetration.
NOTE: If wall is thicker
than 8", attach the flex duct
to the hood then slide the
hood into place.
c
Leyden/Arbor:
Remove the outside air cover
from the bottom of the stove.
Insert the start collar into the
air cover and tap into place
with a mallet. Secure the flex
duct to the start collar using the
included hose clamp.
Cape Cod:
Secure flex duct to air duct
assembly at the rear of the stove
using the included hose clamp.
a
Slide the hood
through the wall
and secure to the
outside wall with
the two included
screws.