Avalon Firestyles D-V-1996 - Manual (Page 8)

P AGE 8
S
TOVE
I
NSTALLATION
(
CONT
.)
- For Qualified Installers Only!
3 Slide the nine U-Nuts into place (see the illustration below).
4 Install the on/off switch (see the illustration below).
?
If installing a thermostat or remote control, do so now (see pages 46 & 47).
5 Disconnect the power cord, insert it through the rear panel, and re-attach it to the molex connector
leading from the heater (see the illustration below).
6 Attach the rear panel to the heater (see the illustration below).
Slide the nine U-Nuts onto the holes
on the top and side panels (with the
flat portion out).
U-Nut
Back of Heater
Rear Panel
Disconnect the power cord, insert it through the rear panel, and
re-attach it to the molex connector leading from the heater.
Attach the rear panel to the
heater with the twelve 10-24
self-tapping screws. Use a
5/16" nutdriver to tighten.
5/16" Nutdriver
Molex
Connection
Disconnect the on/off switch from the red and brown wires
leading from the heater. Insert the switch into the hole in
the upper left of the rear panel until it locks in place. Re-
attach the red and brown wires (orientation does not
matter).
Jumper Wire
(leave in place)