Avalon Firestyles D-V-1996 - Manual (Page 6)

P AGE 6
S
TOVE
I
NSTALLATION - For Qualified Installers Only!
Installation Preparation
! Failure to follow all of the requirements may result in property damage, bodily injury, or even
death.
! This appliance must be installed in accordance with all local codes, if any; if not, follow ANSI
Z223.1 and NFPA 54(88).
! In Manufactured or Mobile Homes must confirm with: In USA, Manufactured Home Construction
and Safety Standard, Title 24 CFR, Part 3280; In Canada, CSA Z240.4 and Gas-Equipped
Recreational Vehicles and Mobile Housing.
This appliance may be installed in Manufactured
Housing only after the home is site located.
! This appliance is designed for natural gas or propane (LP). Check the sticker on top of the gas
control valve.
! All exhaust gases must be vented outside the structure of the living-area. Combustion air is drawn
from outside the living-area structure.
! Notify your insurance company before hooking up this appliance.
! The requirements below are divided into sections - all requirements must be met simultaneously.
ems Required for Installation
• Simpson Duravent with Silicone (see page 12 for part #'s)
• Avanti Pedestal (Part # 99200115)
• Avanti Stove Shell • Gas Hookup Equipment
ems Packed with the Avanti DV
• Avanti DV (with gold door)
• Log Set (2 Logs, 2 Twigs, Embers)
• Two Gas Inlet Pipes (the longer one is for stoves)
• Owner's Manual
• Propane Conversion Kit
• Strain Relief (for power cord)
• Strain Relief Bracket (for inserts only - may be discaded)
ems Packed with the Stove Shell
• Top, Left, Right, and Rear Stove Panels
• Control Cover
• Black Grill
• Eight 10-32 Hex Nuts with Attached Lock Washers
• Two 10-24 Pan Head Screws
• Twelve 10-24 Self-Tapping Screws
• Nine U-Nuts
• Two 6" strips of self-adhesive gasket
• Gas Line Plate
• Left & Right Forward Mounting Brackets
ems Packed with the Pedestal
• Pedestal
• Two 3/8 x 3/4" Bolts
• Two Washers
• Two Lag Bolts
rder of Installation
4 Install the gas inlet (17-1/4" length of 3/8" pipe)
1 If the heater is to use propane, install the propane
conversion kit (see pages 40 - 45)
2 Attach the pedestal
3 Attach the stove shell to the heater
5 Position the heater, use floor protection if needed
6 Connect the gas line. Connect the gas vent.
7 Follow the instructions under "Finalizing the
Installation" on pages 26 through 29.
edestal Attachment
9/16" Wrench
Use a 9/16" wrench to
attach the two pedestal
bolts to the bottom of the
heater.
Lift from here
NOTE: Keep the heater
level to prevent the door
from shifting loose.
The lag bolts and washers
may be inserted through
these holes to anchor the
pedestal to the floor.