Avalon Firestyles D-V-1996 - Manual (Page 7)

S
TOVE
I
NSTALLATION
(C
ONT
.)
- For Qualified Installers Only! P AGE 7
Stove Shell Assembly
1 Follow the directions below to install the side panels to the top panel.
Lay the top panel on a non-
scratching surface upside down.
Apply the two 6" long
gaskets along the
outside of the studs
Right side panel
Left side panel
Attach each Forward Mounting
Bracket with two 10-32 nuts.
Top panel
3/8" Nutdriver
a
b
c
d
Attach the side panels to the top panel with
the four 10-32 hex nuts (the smaller of the
two sizes) until the gasket compresses.
Do not over-tighten
the nuts – this may
cause damage to
the enamel finsih.
2 Follow the instructions below to install the side and top panels.
Slide the top and side panels into place,
making sure they go underneath the wires
and gas line.
7/16" Wrench
Route the on/off switch and blower
wires to the right rear of the heater.
Attach the side panels to the heater
with four 1/4-20 hex nuts (reach in
from the rear of the heater with a
7/16" wrench to tighten).
Attach the forward brackets of
the top panel to the heater with
the two black screws.
Standard
Screwdriver
a
b
c
d