Avalon Firestyles D-V-1996 - Manual (Page 19)

I
NSERT
I
NSTALLATION
(C
ONT
.)
- For Qualified Installers Only! P AGE 19
Installing the Power Cord
1 The power cord may be located on either side. Place the strain relief bracket (included in the owner's
pack) over the two studs and tighten with two 1/4-20 hex nuts (see illustration below).
Back of
Heater
Attach the strain relief bracket
with two 1/4-20 hex nuts.
Disconnect the power cord, insert it through the rear panel, and
re-attach it to the molex connector leading from the heater.
Molex
Connection
7/16" Nutdriver
2 Pull gently on the power cord to take out any extra slack. Attach the strain relief (it is shipped
attached to the power cord - see the illustration below).
Strain
Relief Compress the
strain relief from
the top and
bottom and
insert it into the
hole until it locks
in place.
TO INSTALL THE
STRAIN RELIEF
Power Cord