Auto-Zone Control Systems Auto-Zone CV & CV-EX Systems Installation & Operation (Version 01C) - Manual (Page 29)

Auto-Zone CV & CV-EX
Section 2
Installation and Wiring 2-17
Optional Remote Link II
The Remote Link II is a 14,400 baud modem that can be used with a CommLink IV or a
computer. It is used to provide remote dial-up communications with the CommLink IV.
When it is used as a computer modem (at the remote computer location), it connects to
the remote computer.
Note: WattMaster will not support any other internal or external modems by other
manufacturers.
The OE419-06 Remote Link II connects to the CommLink IV communications interface
at the control system location via a DB9 serial cable. A telephone line connects the
Remote Link to the local phone service. Using another Remote Link modem connected to
a computer and phone service at a remote location, you can monitor and control the
system using the Prism computer front-end software. Connection is made by dialing the
telephone number of the job site where the Remote Link is located. See the Remote Link
II Technical Guide—WM-RLII-TGD for complete product details and installation
instructions.