Audio Enhancement Product Manual - Manual (Page 47)

47
Installing the Bracket
Installing MTBR-07L (STC-98014) for the Ultimate IISE/Innovator Receiver
Amplifier
Please carefully read the following assembly, installation and safety instructions before
installation of MTBR-07L Bracket for Ultimate IISE or Innovator Receiver/Amplifier .
1 . Installation Surface – The enclosed accessories are suitable only for attaching to walls made
of solid concrete or wood studs . Do not install to sheet rock or wood panel .
2 . Tighten all the nuts using the wrench supplied with the mount . The nub must be tightened
until the threading of the screw passes the plastic part of the nut .
3 . Make sure that the MTBR-07L Bracket is installed so the tray is above average head height
and does not disturb free movement in hallways .
4 . You must make sure the MTBR-07L Bracket is secure before setting Ultimate IISE or Innovator
Receiver/Amplifier .
5 . Calculate the maximum weight allowed on the mount by multiplying the specified weight
(this weight will be specified in the packaging of the bracket) by 1 .75 (i .e . weight x 1 .75) .
6 . Check that the Ultimate IISE or Innovator Receiver/Amplifier is securely fastened to the
bracket so it will not fall forward .
7 . One month after installation and every six months thereafter, check that the MTBR-07L Bracket
is securely fastened to the wall and the screws and nuts are not loose . In case of weakening,
remove the Ultimate IISEReceiver /Amplifier and strengthen all the weakened points .
8 . Before reinstalling MTBR-07L Bracket, remove the Ultimate IISE or Innovator Receiver/
Amplifier and then remount according to the instructions in this manual .