Audio Enhancement Product Manual - Manual (Page 40)

40
Step 2 - Bend the ends of the bracket as shown to
allow the mounting of the sensor away from the
mounting surface .
Step 3 - Connect the coaxial cable to the sensor
and mount the sensor to the bracket . Use the two
holes on the end of the bracket to mount it to the
desired surface .
Step 1 - Locate the unmodified mounting bracket .
Step 4 - Check the position of the Channel Selector
(CH) switch . This should be set to ½ position unless
it is being used with a four channel IR system AND
it is the second IR Dome Sensor in the installation .
Then it should be set to the ¾ position .
If the coaxial cables cannot be routed through the ceiling, you
can modify the installation bracket to mount the sensor off of the
surface of the ceiling or wall .
Installation