Artesyn RTM-ATCA-736x-DD Installation and Use (June 2014) - Manual (Page 62)

IPMI Functions List
RTM-ATCA-736X-DD Installation and Use (6806800L82C) 62
5.4.1.1 Disk Eject, Deactivation Request to Power-off Disk
This command produces the same response as pressing one of the disk eject buttons on the
RTM panel.
Upon completion of the OS removal preparations, the user may issue an IPMI raw command
and subsequently illuminate the disk FRU hot swap LED.
5.4.1.2 Approve Disk Eject Request
If the RTM is operating in slave mode (see Typical Module Slave Extraction Mode (Normal), on
page 66 ), the host must explicitly approve a disk eject request using this command.
Before ejecting a drive, the user should ensure the OS has released the drive, meaning it has
to be unused. This usually requires unmounting any file systems on it, and terminating any
raw partition use.
Table 5-5 IPMI Raw Command Disk Removal Request
Raw Command Description
netfn 0x2E
cmd 0xA0
data 0xA4 0x76 0x00 0xZZ
Where 0xZZ indicates the disk drive:
0x01 is disk#1, 0x02 is disk#2.
Any other 0xZZ value will trigger completion code 0xCC
Return code 0x00 - Success
0xCC - Invalid Data in Request
Return Data 0xA4 0x76 0x00
Table 5-6 IPMI Raw Command to Approve Disk Power Eject Request
Raw command Description
netfn 0x2E