Artesyn RTM-ATCA-736x-DD Installation and Use (June 2014) - Manual (Page 47)

Mechanical and Connector Information
RTM-ATCA-736X-DD Installation and Use (6806800L82C) 47
4.1.5 NEBS Compliance
NEBS certifications are performed by integrator at a system level (chassis, ATCA, shelf
managers, etc.). The RTM module will not preclude the system from passing NEBS.
4.1.6 Electromagnetic Compliance
The board is designed and implemented to minimize electromagnetic emissions,
susceptibility, and the effects of electrostatic discharge.
Vibration, non-operating 3.1 mm (5 to 20Hz) / 49m/s2 (5G)
(20 to 300Hz) or less. Note: At
power-off state after installation 3.13 GRMS (5-800Hz)
RoHS 6 of 6 compliant 6 of 6 compliant
MTBF Not calculated 972,226 hours (@25C)
Table 4-2 Environmental Specifications for the RTM-ATCA-736X-DD (continued)
Specification
RTM with rotating SAS Disk Media
Installed
RTM without Disks
Table 4-3 EMC Emission Compliance
Standard Description
US: FCC 47 CFR Part 15 Class A FCC Class A emissions requirements (United States)
ICES-003 2004 Class A Class A Interference-causing Equipment standard (Canada)
VCCI V-3/2007.04 Class A Class A ITE emissions requirements (Japan)
Europe Commercial: EN5022:2006 Class A, ITE Class A ITE emissions requirements (EU, Europe)
AS/NZS CISPR 22:2005 Class A, ITE Class A ITE emissions requirements (Australia)
Europe Commercial: EN
55022:1998/A1:2000/A2:2003 Immunity for ITE equipment
Europe Commercial: EN
55024:1998A1:2001/A2:2003 Immunity for ITE equipment
Europe Commercial: EN 61000-4-2,3,4,5,6: 2001 EMC Electrostatic discharge immunity