Artesyn RTM-ATCA-736x-DD Installation and Use (June 2014) - Manual (Page 16)

Introduction
RTM-ATCA-736X-DD Installation and Use (6806800L82C) 16
 Two recessed push button switches for disk FRU eject request
 Temperature and voltage sensors
 OOS, health, alarm, and hot swap LEDs
 On-board MMC controller for management activities (IPMI)
1.3 I/O PICMG Standards Compliance
The RTM-ATCA-736X-DD is fully compliant with the following PCI Industrial Computer
Manufacturers Group (PICMG) specifications:
 PICMG 3.0 Rev 3.0
 PICMG AMC.0 Rev2.0 compliance
 IPMI v1.5 Intelligent Platform Management Interface Specification
 PCI Express 2.0 and 1.0a specifications
1.4 I/O Interfaces
The RTM-ATCA-736X-DD mounts to the ATCA carrier blades using zone-3 connectors,
conforming to PICMG 3.0 ATCA specification revision 3. Internally, the RTM-ATCA-736X-DD
connects zone-3 and the RTM faceplate as follows:
Table 1-1 I/O Ports Available On RTM Faceplate
RTM Zone-3 Electrical Signaling RTM Faceplate
PCIe v1.0, x4 bus #1 Port 1 RJ45 1000Base-T
Port 2 RJ45 1000Base-T
PCIe v1.0, x8 bus #2 SAS disk field replaceable assembly #1
SAS disk field replaceable assembly #2
DCA_SAS, x2 Routes to secondary ports of each SAS drive
LSI_SAS, x2 NA (Routes to LSI Controller)
IPMI - to MMC device on RTM NA
Power NA