Artesyn RTM-ATCA-736x-DD Installation and Use (June 2014) - Manual (Page 25)

Chapter 2
RTM-ATCA-736X-DD Installation and Use (6806800L82C) 25
Installation
2.1 Overview
This chapter contains the procedures for installing and removing the RTM-ATCA-736X-DD
RTM.
2.2 Installation and Removal of the Rear Transition
Module
The RTM-ATCA-736X-DD can be installed into an ATCA shelf (chassis) with a midplane made for
front and rear board installations. The module must be installed in the slot directly behind the
host ATCA node board. These back-to-back slots have common pins to enable passing of
signals using the Zone-3 connector complex.
2.3 Important Information about Your Chassis
Before installing the rear transition module, verify the module's part number to ensure that the
correct rear transition module is being installed into the system. For information on identifying
the rear transition module, see
Products Supported by this Manual, on page 20 .
2.3.1 Safety Statement
The RTM-ATCA-736X-DD is designed to comply with IEC60950-1, and is intended to be used
with similarly tested AdvancedTCA products that have a user's guide detailing user installation
of module accessories.
2.3.2 Observe Maximum Module Current Requirements
There are several manufacturing options for the RTM. Be sure to validate that the host chassis
can supply the RTM slot with these maximum current requirements.
Table 2-1 Maximum RTM Module Current Requirements
Module Current
RTM-ATCA-736X-DD
(No Disk)
RTM-ATCA-736X-DD (Two SAS Disk)
+12 V (spin up < 100 sec) 0.55 A (6.6 W) 1.9 A (22.9 W) (staggered spin-up)