Artesyn RTM-ATCA-736x-DD Installation and Use (June 2014) - Manual (Page 19)

Introduction
RTM-ATCA-736X-DD Installation and Use (6806800L82C) 19
1.6 Disk "Request Eject" Button
The RTM-ATCA-736X-DD includes a pair of recessed eject buttons that is marked on the panel
near port 1 (
Figure 1-2 ). Using a thin pointed object, such as a paper clip, a user can depress the
eject button. This action will send a message to the front blade requesting the disk ejection
reset. If granted, the corresponding hard disk status light will turn amber.
1.7 Reset Button
The RTM-ATCA-736X-DD includes a recessed reset button that is located between the two
Ethernet ports (see
Figure 1-2 ). Using a thin pointed object, such as a paper clip, a user can
depress the reset button. This action will send a message to the front blade requesting a
payload reset. If granted, the host blade and all peripherals will experience a warm reset.
1.8 Software Support
Except for the drivers for the 82580 Ethernet controller (driver distributed by Intel) and for the
SAS1064E controller (driver distributed by LSI) , RTM-ATCA-736X-DD requires no other special
software to operate. When shipped from the factory, the expander is un-zoned and configured
for table routing.
Figure 1-2 RTM-ATCA-736X-DD Back Panel LEDs