Artesyn MVME8100 RTM (VXS1-RTM1) Installation and Use (April 2015) - Manual (Page 48)

Controls, LEDs, and Connectors
VXS1-RTM1 Installation and Use (6806800P46C) 48
3.1.2.2.15 RTM GPIO Connector P5
The RTM provides one 8 pin planar header connector for GPIO signals. The pin assignment of
this connector is as follows:
3.1.3 Switches
One 6 position switch is provided for RTM. The default setting on all switch positions is OFF.
3.1.3.1 RTM Configuration Switch
Pin assignment of RTM switch S1 is shown below:
9 I2C_SDA
10 GND
Table 3-16 RTM CPLD Programming & Debug Header (P2) (continued)
Pin Name Signal Name
Table 3-17 GPIO Header (P5)
Pin Name Signal Name
1 GPIO0
2 GND
3 GPIO1
4 GND
5 GPIO2
6 GND
7 GPIO3
8 GND
Table 3-18 RTM Configuration Switch (S1)
Pin Name Signal Name ON OFF
SW6 SW2_CPLD Reserved