Artesyn MVME8100 RTM (VXS1-RTM1) Installation and Use (April 2015) - Manual (Page 44)

Controls, LEDs, and Connectors
VXS1-RTM1 Installation and Use (6806800P46C) 44
3.1.2.2.11 RTM PIM Connector J10
The RTM provides two PMC connectors J10 and J14 for PMC rear I/Os signals. These connectors
are used to install PIM module. The pin assignment of J10 connector is shown below. The pin
assignment of J14 is shown in
Table 3-14 .
B3 ESATA2_TX_N
B4 GND
B5 ESATA2_RX_N
B6 ESATA2_RX_P
B7 GND
Table 3-12 Dual eSATA Connector (J6) (continued)
Pin Name Signal Name
Table 3-13 PIM Connector (J10)
Pin Name Signal Name Pin Name Signal Name
1 NC 33 NC
2 NC 34 GND
3 NC 35 NC
4 NC 36 NC
5 +5V_RTM 37 +5V_RTM
6 NC 38 NC
7 NC 39 NC
8 NC 40 NC
9 NC 41 NC
10 +3V3_RTM 42 +3V3_RTM
11 NC 43 NC
12 NC 44 NC
13 GND 45 GND
14 NC 46 NC