Artesyn MVME8100 RTM (VXS1-RTM1) Installation and Use (April 2015) - Manual (Page 45)

Controls, LEDs, and Connectors
VXS1-RTM1 Installation and Use (6806800P46C) 45
3.1.2.2.12 RTM PIM Connector J14
The RTM provides two PMC connectors J10 and J14 for PMC rear I/Os signals. These connectors
are used to install PIM module. The pin assignment of J14 connector is shown below.
15 NC 47 NC
16 NC 48 NC
17 NC 49 NC
18 GND 50 GND
19 NC 51 NC
20 NC 52 NC
21 +5V_RTM 53 +5V_RTM
22 NC 54 NC
23 NC 55 NC
24 NC 56 NC
25 NC 57 NC
26 +3V3_RTM 58 +3V3_RTM
27 NC 59 NC
28 NC 60 NC
29 GND 61 NC
30 NC 62 NC
31 NC 63 NC
32 NC 64 NC
Table 3-13 PIM Connector (J10) (continued)
Pin Name Signal Name Pin Name Signal Name
Table 3-14 PIM Connector (J14)
Pin Name Signal Name Pin Name Signal Name
1 PMC_IO<1> 33 PMC_IO<33>
2 PMC_IO<2> 34 PMC_IO<34>