Artesyn MVME8100 RTM (VXS1-RTM1) Installation and Use (April 2015) - Manual (Page 28)

Hardware Preparation and Installation
VXS1-RTM1 Installation and Use (6806800P46C) 28
The power requirements for the RTM are as follows:
2.3 RTM Installation and Removal
The RTM does not support hot swap, you should remove power to the rear slot or system
before installing the module. Before installing the transition module, you may need to
manually configure the switch and install a PMC I/O Module (PIM).
Table 2-3 Power Requirements
RTM CONFIGURATION +5.0V TOTAL POWER
Air Cooled 0.25 A 1.25 W
Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or shorten
their life.
Before touching the board or electronic components, make sure that you are working in an ESD-
safe environment.
Product Damage
Only use injector handles for board insertion to avoid damage to the front panel and/or PCB.
Deformation of the front panel can cause an electrical short or other board malfunction.
Board Malfunction
Switches marked as “reserved” might carry production-related functions and can cause the
board to malfunction if their setting is changed.
Do not change settings of switches marked as “reserved”. The setting of switches which are not
marked as “reserved” has to be checked and changed before board installation.