Artesyn MVME8100 RTM (VXS1-RTM1) Installation and Use (April 2015) - Manual (Page 47)

Controls, LEDs, and Connectors
VXS1-RTM1 Installation and Use (6806800P46C) 47
3.1.2.2.13 RTM Reset Connector P1
The RTM provides one 2 pin planar header to connect reset switch on its front panel. The pin
assignment for this connector is as follows:
3.1.2.2.14 RTM CPLD Programming and Debug Connector P2
The RTM provides one 10 pin planar header to connect JTAG signals to program CPLD. The
connector also provides access to I2C bus for de-bugging. The pin assignment of this connector
is as follows:
30 PMC_IO<30> 62 PMC_IO<62>
31 PMC_IO<31> 63 PMC_IO<63>
32 PMC_IO<32> 64 PMC_IO<64>
Table 3-14 PIM Connector (J14) (continued)
Pin Name Signal Name Pin Name Signal Name
Table 3-15 RTM Reset Switch Connector (P1)
PIN# SIGNAL
1 RTM_RST#
2 GND
Table 3-16 RTM CPLD Programming & Debug Header (P2)
Pin Name Signal Name
1 +3V3
2 TMS
3 NC
4 TCK
5 NC
6 TDI
7 I2C_SCL
8 TDO