beautypg.com

2 nvram, 3 quad uart (quart), 4 control and timers pld – Artesyn MVME7100ET Single Board Computer Installation and Use (June 2014) User Manual

Page 76: 2 nvram 4.8.3 quad uart (quart)

background image

Functional Description

MVME7100ET Single Board Computer Installation and Use (6806800K87E)

76

4.8.2

NVRAM

The MVME7100ET includes one Freescale 512 MB MRAM device connected to the MC864xD
device control bus to provide a non-volatile memory that has unlimited writes, fast access and
long term data retention without power. The MRAM is organized as 256 K by 16. Refer to the
datasheet for additional information

4.8.3

Quad UART (QUART)

The MVME7100ET contains one Quad UART device connected to the MC864xD device control
bus to provide additional asynchronous serial ports. The Quad UART provides four
asynchronous serial ports which are routed to the P2 connector. The TTL-level signals of RX, TX,
CTS, and RTS from each port are routed through on-board RS-232 drivers and receivers to the
P2 connector where the signals can be picked up by a transition module. The reference clock
frequency for the QUART is 1.8432 MHz. All UART ports are capable of signaling at up to 115
Kbaud. Refer to the ST16C554D datasheet for additional details and/or programming
information.

4.8.4

Control and Timers PLD

The MVME7100ET Control and Timers PLD resides on the local bus. The Control and Timers
PLD provides the following functions on the board:

Local bus address latch

Chip selects for flash banks, MRAM, and Quad UART

System control and status registers

Four 32-bit tick timers

Watch Dog Timer

RTC 1 MHz reference clock