6 installing and removing the board, Installing and removing the board – Artesyn MVME7100ET Single Board Computer Installation and Use (June 2014) User Manual
Page 44

Hardware Preparation and Installation
MVME7100ET Single Board Computer Installation and Use (6806800K87E)
44
2.6
Installing and Removing the Board
This section describes a recommended procedure for installing a board module in a chassis.
The MVME7100ET does not support hot swap, you should remove power to the slot or system
before installing the module. Before installing the MVME7100ET, ensure that the serial ports
and switches are properly configured.
Installation and Removal Procedure
Before you install your module, read all cautions, warnings, and instructions described in this
section.
Use the following steps to install the MVME7100ET into your computer chassis.
1. Attach an ESD strap to your wrist. Attach the other end of the ESD strap to an
electrical ground. The ESD strap must be secured to your wrist and to ground
throughout the procedure.
2. Remove any filler panel that might fill that slot.
3. Install the top and bottom edge of the MVME7100ET into the guides of the chassis.
4. Ensure that the levers of the two injector/ejectors are in the outward position.
5. Slide the MVME7100ET into the chassis until resistance is felt.
6. Simultaneously move the injector/ejector levers in an inward direction.
Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or
shorten their life.
Before touching the board or electronic components, make sure that you are working in an
ESD-safe environment.
Product Damage
Only use injector handles for board insertion to avoid damage to the front panel and/or PCB.
Deformation of the front panel can cause an electrical short or other board malfunction.