Artesyn MVME7100ET Single Board Computer Installation and Use (June 2014) - Manual (Page 50)

Controls, LEDs, and Connectors
MVME7100ET Single Board Computer Installation and Use (6806800K87E) 50
3.3.3 Connectors
This section describes the pin assignments and signals for the connectors on the
MVME7100ET. The table below lists the standard connectors on the MVME7100ET baseboard.
Refer to
Figure 3-1 on page 47 for connector locations. Pin assignments for the connectors are
in the following sections. Some connectors use standard pin assignments in compliance with
the VMEbus, IEEE, PCI, and ANSI/VITA specifications. Links to these specifications are located at
Appendix B, Related Specifications, on page 120 .
Table 3-2 Baseboard Connectors
Reference
Designator
Function Notes
J6 XMC Expansion 8X PCI-E to XMCSpan
J4A TSEC 1, 10/100/1000 Ethernet RJ-45
J4B TSEC 2, 10/100/1000 Ethernet RJ-45
J11, J12, J13, J14
J21, J22, J23 PMC1
PMC2 Implementing all recommended and
optional VITA32 signals except
RESETOUT#
J1 Port 0. Serial Port 1 Mini DB-9 console serial port
P1 VME five-row P1
P2 VME five-row P2 on SBC and RTM TSEC3 signals assigned to E1-1 thru E1-4
TSEC4 signals assigned to E2-1 thru E2-4
Serial ports 2-5
P4 Processor COP header
P5 Boundary Scan header