Artesyn MVME7100ET Single Board Computer Installation and Use (June 2014) - Manual (Page 104)

MOTLoad Firmware
MVME7100ET Single Board Computer Installation and Use (6806800K87E) 104
6.5.4 Editing VME Settings
To edit the changeable VME setting, type the following at the firmware prompt:
 Edits Master Enable state:
vmeCfg –e –m
 Edits selected Inbound Window state:
vmeCfg –e –i(0 - 7)
 Edits selected Outbound Window state:
vmeCfg –e –o(0 - 7)
 Edits Master Control Register state:
vmeCfg –e –r234
 Edits Control Register state:
vmeCfg –e –r238
 Edits CRG Attribute Register state:
vmeCfg –e –r414
6.5.5 Deleting VME Settings
To delete the changeable VME setting (restore default value), type the following at the
firmware prompt:
 Deletes Master Enable state:
vmeCfg –d –m
 Deletes selected Inbound Window state:
vmeCfg –d –i(0 - 7)
 Deletes selected Outbound Window state:
vmeCfg –d –o(0 - 7)
 Deletes Master Control Register state:
vmeCfg –d –r234
 Deletes Control Register state:
vmeCfg –d –r238
 Deletes CRG Attribute Register state:
vmeCfg –d –r414