beautypg.com

1 transition module, Transition module – Artesyn MVME7100ET Single Board Computer Installation and Use (June 2014) User Manual

Page 40

background image

Hardware Preparation and Installation

MVME7100ET Single Board Computer Installation and Use (6806800K87E)

40

2.5.1

Transition Module

The MVME721ET does not support hot swap, You should remove power to the rear slot or
system before installing the module. Before installing the MVME721ET transition module, you
may need to manually configure the switch and install a PMC I/O Module (PIM). Refer to

Chapter 5, Transition Module

, for switch settings and PIM installation.

Installation and Removal Procedure

To begin the installation of the transition module in a chassis, proceed as follows:

1. Turn all equipment power OFF and disconnect the power cable from the AC power

source.

2. Remove the chassis cover as instructed in the equipment user's manual.

3. Remove the filler panel(s) from the appropriate card slot(s) at the rear of the chassis

(if the chassis has a rear card cage).

4. Install the top and bottom edge of the transition module into the rear guides of the

chassis.

Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or shorten
their life.
Before touching the board or electronic components, make sure that you are working in an
ESD-safe environment.

Product Damage
Only use injector handles for board insertion to avoid damage to the front panel and/or PCB.
Deformation of the front panel can cause an electrical short or other board malfunction.

Board Malfunction
Switches marked as “reserved” might carry production-related functions and can cause the
board to malfunction if their setting is changed.
Do not change settings of switches marked as “reserved”. The setting of switches which are
not marked as “reserved” has to be checked and changed before board installation.