Artesyn COMX-CORE Series Installation and Use (August 2014) - Manual (Page 19)

Introduction
COMX-CORE Series Installation and Use (6806800K11F) 19
Table 1-2 COMX-CORE-510/710/750 (non-ECC) Features Summary
Function Features
Processor/ Memory Controller  Arrandale+ECC Processor
–
Multi-chip package
– Integrated Graphics and Memory Controller Hub
(GMCH)
– 3 MB or 4 MB integrated L3 cache
– Core frequency
- COMX-CORE-510 2.4GHz ( i5-520E )
- COMX-CORE-750 2.0GHz (i7-620LE)
- COMX-CORE-710 1.06GHz (i7-620UE)
 Ibex Peak-M Platform Controller Hub (PCH)
–
Intel Calpella QM57 Platform Controller Hub
BIOS Device Two 4 MB SPI flash
Memory  Two DDR3 800/1066 64-bit SO-DIMM sockets.
Maximum memory capacity is 8GB non ECC memory
eUSB Flash Optional 1 GB low profile eUSB flash
Video  Supports Low Voltage Differential Signaling (LVDS)
 Supports Video Graphics Adapter (VGA)
 Supports High-Definition Multimedia Interface
(HDMI)
 Supports up to two display ports
Audio Ibex Peak-M supports HDA. The signals are routed to the
COM-E connector. The audio CODEC should be on the
carrier board.
Ethernet Optional 1x 10/100/1000Base-T GbE port based on
WG82577LM routed to the COM Express connector
USB Eight USB2.0 ports routed to the COM Express connector
PCI Express Supports up to eight PCI Express ports routed to the
COM Express connector
Serial ATA Four SATA 3.0 Gbps ports routed to the COM Express
connector
LPC LPC bus routed to the COM Express connector
SMBus I
2
C compatible SMBus is routed to the COM Express
connector