AMETEK SLH Series RevC - Manual (Page 88)

Appendix B Sorensen SLH-Series DC High Power Electronic Load
B-4 M540074-01 Rev C
WARNING
The following connections should be made with power disconnected from the load.
Load Input Bus Bar Parallel Connection
Use the L-type bus bars to parallel positive terminals on the rear panel (positive is located
on the right as you face the rear panel), and to parallel all negative terminals (negative is
located on the left as you face the rear panel). Refer to Figure 2. Wire the system
Positive and Negative (+ and -) load input, from any point of the Bus Bar. The unused
screw holes on the Bus Bar are designed for your load input wiring connection.