AMETEK SLH Series RevC User Manual
Page 80

Remote Programming
Sorensen SLH-Series DC High Power Electronic Load
MEAS:VOLT?{NL}
Description:
MEAS:VOLT? returns the present 4 1/2 digital voltage meter reading. The returned data format is
shown in Table 4-2, the engineering unit is “V”.
CURRENT METER
Purpose:
The reading of 4 1/2 digit current meter read back query command.
Command Syntax:
MEAS:CURR?{NL}
Description:
MEAS:CURR? returns the present 4 1/2 digital current meter reading. The engineering unit is “A."
POWER METER
Purpose:
To read the value of Watt meter.
Command Syntax:
MEAS:POW?{;|NL}
Description:
MEAS:POW? Reads back the value of 4 1/2 digit of the Watt meter; unit is (W).
SENSE ON/OFF
Purpose:
To read the setting condition of Sense ON or OFF.
Command Syntax:
SENS?{;|NL}
Description:
SENS? Reads back the setting condition of SENS. “0” denotes OFF, “1” denotes Auto.
WATT Meter ON/OFF
Purpose:
To read the setting condition of WATT.
Command Syntax:
WATT?{;|NL}
Description:
WATT? Reads back the setting condition of WATT. “0” denotes OFF, “1” denotes ON.
VOLTAGE Limit
Purpose:
To read the set value of upper/lower limit value of threshold voltage.
Command Syntax:
LIM:VOLT:{HIGH/LOW}?{;|NL}
Description:
LIM:VOLT:LOW? Reads back the lower limit set value of threshold voltag;, unit is “volts" (V).
5-18
M540074-01
Rev C