AMETEK SLH Series RevC - Manual (Page 66)

Remote Programming Sorensen SLH-Series DC High Power Electronic Load
STATE Command RETURN
[STATe:] LOAD{SP}{ON|OFF}{;|NL}
0=OFF, 1=ON
[STATe:] LOAD{?}{;|NL}
[STATe:] MODE{SP}{CC|CR|CV|CP}{;|NL}
0=CC, 1=CR [STATe:] MODE{?}{;|NL}
2=CV, 3=CP
[STATe:] SHORt{SP}{ON|OFF}{;|NL}
0=OFF, 1=ON [STATe:] SHORt{?}{;|NL}
[STATe:] PRESet{SP}{ON|OFF}{;|NL}
0=OFF, 1=ON [STATe:] PRESe{?}{;|NL}
[STATe:] SENSe{SP}{ON|OFF}{;|NL}
0=OFF, 1=ON [STATe:] SENSe{?}{;|NL}
[STATe:] LEVEl{SP}{HIG|LOW|AIB}{;|NL}
0=LOW, 1=HIGH [STATe:] LEVEl{?}{;|NL}
1=AUTO,
2=RANGE II
[STATe:] RANG{?}{;|NL}
[STATe:] DYNamic{SP}{ON|OFF}{;|NL}
0=OFF, 1=ON [STATe:] DYNamic{?}{;|NL}
[STATe:] WATT{SP}{ON|OFF}{;|NL}
0=OFF, 1=ON [STATe:] WATT{?}{;|NL}
[STATe:] CLEar{;|NL}
Dddddddd [STATe:] ERRor{?}{;|NL}
0=OK, 1=NG [STATe:] NG{?}{;|NL}
Dddddddd [STATe:] PROTect{?}{;|NL}
Table 5-4 State Command Summary
COMMAND NOTE RETURN
[SYStem:] RECall{SP}{m[,n]}{;|NL} M=1~5 n=1~30
[SYStem:] STORe{SP}{m[,n]}{;|NL} M=1~5 n=1~30
[SYStem:] REMOTE{;|NL} Only RS232 cmd
[SYStem:] LOCAL{;|NL} Only RS232 cmd 0=:OFF, 1=:ON
[SYStem:] NAME{?}{;|NL} “ XXXXX＂
Table 5-5 System Commands - All Modules
5-4 M540074-01 Rev C