AMETEK CW-M - Manual (Page 41)

M161570-01 5-1
SECTION 5
OPERATION
The controls and indicators for the CW series power source are detailed
below in Figure 5-1.
Figure 5-1. CW Front Panel Controls
 POWER SWITCH
Press the top portion of the switch to turn power on, press the bottom portion of the switch
to turn the power supply off. When power is turned on, the unit goes through a power up
cycle that may take several seconds before it is ready for operation.
 VOLTAGE CLUSTER
These five controls and indicators, located to the right of the Power Switch, are used to
select and display the
power supply’s output voltage.