AMETEK CW-M - Manual (Page 33)

M161570-01 4-1
SECTION 4
SET-UP
Once installation is complete and all cable connections are secure, check
the settings on the 12-position CONFIG dipswitch located on the rear
panel. Refer to Figure 4-1. Configure the switch prior to applying unit
power.
Figure 4-1. CW Rear Panel
4.1 CONFIG DIPSWITCH
The CONFIG dipswitch comes preset from the factory for stand-alone
operation. With these settings, the unit powers up to the current voltage
and operates in constant current mode. The dipswitch settings should look
like this:
1 2 3 4 5 6 7 8 9 10 11 12
ON
OFF
Figure 4-2. Config Dipswitch, Factory Default Settings
The functions of the CONFIG dipswitch are listed in Table 4 –1, followed by
descriptions of switch positions to change the default attributes of the unit.