AMETEK CW-M - Manual (Page 21)

Elgar CW-M Series
M161570-01 3-5
3.3 MOUNTING INSTRUCTIONS
Refer to Figure 3-1 through Figure 3-4 for mounting dimensions and other
installation information for the CW Series power supplies.
The units are equipped with mounting feet for bench top use. They are
mounted to the chassis with pem-nuts and may be removed easily for rack
mount application.
The units are 3.5" and 5.25" (89 mm and 133 mm) high, and are designed
to be installed in a standard 19" (483 mm) RETMA rack. Pem-nuts have
been built into the chassis for mounting optional slides. The CW mounting
kit, Elgar part number K161570-01, contains the appropriate slides and
mounting brackets.
If you elect not to use slides, mount the unit with standard support angles
to sustain the weight of the unit in the rack. Note that the front panel
mounting ears are not intended to support its weight in rack mounting.
For installations that include slides, use a #10 lock washer with each of the
two mounting screws indicated in Figure 3-1. The washers are required on
the right side only.
Figure 3-1. Slide Mounting