4. setup – device mode – AGI Security SYS-HD0420A User Manual
Page 29
29 |
P a g e
3-4. Setup – Device Mode
In the SETUP menu, select the DEVICE tab
. Then, the device menu is displayed as pictured below. Navigate
through the menu items using the mouse or the control button on the remote control and change the value of the
menu item.
Figure 3.4.1. Device Mode Setup Screen
Table 3.4.1. Menu Items in Device Setup Screen
Item
Description
ALARM OUT
Set/allocate the alarm triggers, Sensor, Motion, Video loss, and Alarm
duration for each alarm-out.
CONTROLLER & PTZ
Set the controller to control DVR and PTZ cameras.
CHANNEL
Select specified channel for motion zone setup.
MOTION ZONE
Select either Full Zone or Partial Zone for motion sensing.
MOTION SENSITIVITY Set the motion sensitivity for the specified channel.
Control the motion sensitivity from 1 to 9.
KEY TONE
Enable/disable key tone.
REMOTE CONTROLLER
ID
Select an ID of remote control.
1. Select ID number.
2. Press the same number as ID set in DVR on the remote control.
3. An icon will be displayed on the Live Screen that corresponds to the
remote control ID number.0
The options are from 0 to 99
SENSOR
Select sensor number to set the type of sensor.
TYPE
Set the type of sensor for the specified channel.
Options are: OFF, NORMAL OPEN, or NORMAL CLOSE.