Adtec digital EN-91 / EN-91P (version 1.02.29) Manual - Manual (Page 12)

Front Panel Menu Structure
Services Menu
Item Function Options
TS Mux
Rate Transport Mux Rate is the total transport
stream rate. Use this number to match total
circuit throughput
1000000 - 100000000
note: The actual lower limit
is configuration dependent.
Program
Number Sets the program number in the PAT
(Program Association Table). This value is in
decimal format.
1 - 8190
ABR Mode The Adaptive Bit-rate mode allows the
encoder to adjust TMR and Video bit-rate
without performing an encoder restart. This
mode is useful for dynamic bandwidth based
solutions.
When this configuration is set to OFF, the
default configuration, bit-rate changes to TMR
or Video rate will restart the encoder if
required. With this configuration set to ON,
bit-rate changes to TMR or Video rate will not
restart the encoder.
Note: With this mode enabled, a transport
stream analyzer will show a PCR accuracy
error on TMR changes. This is a type of "false
alarm" if the error occurs during a bit-rate
transition, the decoder adapts dynamically to
the change.
*This is an optional feature
OFF
ON
Service
Name
Identifies the service by name. This value is
used to populate either the DVB SDT table, or
ATSC VCT table. You are limited to 20
characters in DVB mode and 7 in ATSC mode.
When using Bars, Tones and ID overlays, this
field is displayed as part of the service
information.
1- 20 ascii characters in DVB
mode
1-7 ascii characters in ATSC
mode