4 adept smi6 hardware configuration, Smi6 digital input logic voltage configuration – Adept SmartMotion User Manual
Page 21
Adept sMI6 Hardware Configuration
Adept SmartMotion Installation Guide, Rev. C
21
2.4
Adept sMI6 Hardware Configuration
sMI6 Digital Input Logic Voltage Configuration
The sMI6 can be configured to operate with either a 5V (min 3.0V, max 5.7V) or a 12/24V
(min 8.75V, max 27.5V) logic interface. This affects the Home, Overtravel, and Drive Fault
signals. The sMI6 is normally shipped configured for 12V input, and must be
reconfigured if you decide to operate at 5V. After you configure the sMI6 voltage option,
then you must install the MP6 Machine and Servo panels accordingly.
NOTE: Refer to
Figure 4-5 on page 53
for a typical input circuit in the
sMI6.
The input voltage is determined by jumpers on the main printed circuit assembly (PCA)
inside the chassis. To reconfigure the sMI6 for 5V logic operation, follow this procedure.
1. Verify that the sMI6 is disconnected from the 24VDC power source.
2. Remove the cover of the chassis by removing three screws at the back of the
.
3. Install jumpers for each channel that you are using. See
4. Reinstall the cover on the chassis.
Figure 2-4. Opening the sMI6 Chassis