Zilog Z86E07 - Manual (Page 24)

3-4
C50 ICEBOX
U SER ' S M ANUAL
Using the Debug Window
13. Open the Debug window.
The content of the Program (Code) Memory is disassembled and listed here. You can
do line-down or page-down to get around in the code list, but
page-up or line-up is
not supported . You can do a direct jump to any particular memory address.
14. Set a break point and start the program by clicking the GO button.
Notes:
1. The mouse cursor is changed to a sand glass shape. The only action allowed
after a “GO” is halt. If there are no break points, click on the HALT button
to halt the execution.
2. If the application inadvertently goes into STOP Mode, the only way to halt the
emulator execution is by doing a Stop-Mode Recovery (as defined by the user
program). You may also reset the application using the RESET button.
15. Click on the HALT button to halt an execution.
OTP Operations
16. Select the OTP menu item under the Code Memory menu or Debug menu of the
emulator. An OTP dialog box is opened from which you can perform the operations
of OTP. Close the OTP window by selecting the Quit menu item.
Window Refresh
17. Double click on caption bar of the Register window to refresh it and check the value
of the registers.
Saving and Quitting
18. Select “Save Session” from the File menu to save the current setting in a session file.
The next time you use the interface, you can reload the last session by using the “Load
Session” command in the File menu.
19. Quit the application.
UM009701-0201