Installing the hardware (continued) – Zilog Z86E07 User Manual

Page 14

2-4

C50 ICEBOX

SER

ANUAL

INSTALLING THE HARDWARE

(Continued)

Connecting to Your Design.

(If your design is ready.) Locate the emulation cable for your

CCP

™

-based design.

Note:

Wear a properly grounded wrist strap or similar ESD protection before proceeding

with this step.

Plug one end of the emulator cable into your Z8 CCP socket, being

very careful

to orient

the Pin 1 marking (as indicated by the red mark on the ribbon cable) to match the way your
board is built. Plug the other end of the cable into the matching blue connector on top of
the emulator.

Note:

The inductance and capacitance of the emulation cable may affect the signals to

and from the emulator and target board, especially if the target board has low-current
drivers, pull-ups, and pull-downs. We recommend that you drive the XTAL pins of the Z8

with the crystal oscillator on the emulator with the J2/J3 Jumpers removed.

Figure 2-2. Emulator Hook-Up Diagram

UM009701-0201

This manual is related to the following products:

Z86E30